Kenmore ice maker hookup
Pull the Kenmore out from the wall so you can get behind the appliance to access the connections. Slip the compression nut that came with the kit over the newly installed supply line. All Departments Andalucia dating sites Departments.
The web site is the perfect place to get this kind of advice. Twist the faucet supply line onto the female end of the adapter.
About the Author
Open the freezer door and remove any frozen food blocking the upper back wall. I paid Sears to install the fridge but they did not connect the icemaker or water dispenser at that time because the house where I lived didn't have any water lines. I hope this will help you. Unplug the refrigerator power rockabilly dating site australia. Trio Bottom Freezer Refrigerator.
Skip to main content. Wrap plumber's resin-coated tape around the nozzle threads on the back of the refrigerator, on the freezer side near the top. Thread the water line, included in the ice maker installation kit, from the area behind the refrigerator to beneath the sink. Drill holes in the base cabinet walls to route the water line from beneath the hookup to the rear of the refrigerator.
Pry off the plate labeled "Icemaker" with a flat-blade screwdriver inserted into the notch at the bottom. Don't show me this message again. It will normally be on the right side of the refrigerator and held in place with a couple of screws.
Use pliers to untwist the faucet supply line from the cold water supply valve. Push the refrigerator against the wall. Enter text from picture: Tighten the connections slightly if you see a leak. To prevent ices maker and product damage, do not hook up.
Slide the coupler on the end of the water line over the taped nozzle on the back of the Kenmore. Turn on the nearest faucet to relieve the pressure on. I attached the link below.
I'm also attaching a link to a video ice you to watch and I hope it will help you. Twist the male end of a quick-tee adapter onto the valve.
Some models of Kenmore-brand refrigerators manufactured by Sears are equipped with mounting brackets and a power socket for connecting an optional icemaker.
Press the toggle switch on the icemaker to the ''On" position and replace any frozen food you removed earlier. Can you please tell me how to do the job and what makers and parts I need? Wrap threads on the cold water valve with two or three wraps of thread-seal tape.
Slide the nut and then the ferrell on the hookup end of the copper tube. By pressing 'print' button you will print only current page. Do not install the icemaker tubing in areas where. Copyright Leaf Group Ltd. Was This Manual Helpful? Then add 8 feet. Don't have an account? I hope the provided information is useful to you.